vurtaxi.blogg.se - Port forwarding teamviewer wake on lan

Right-click the network adapter of your computer and select Properties.Ĭlick the Advanced tab. Right-click the Computer icon and select Properties.Ĭlick the arrow beside Network adapters to expand the category. To enable Wake on LAN on your computer, click on the applicable operating system: NOTE: For information if your operating system supports WoL, you may contact the manufacturer’s technical support.

all routers between the remote location and computer required to WoL must allow IP directed broadcasts and support IPv4.

computer basic input/output system (BIOS) configured for WoL.

network adapter and adapter driver that supports the standard Magic Packet format.

a wired connection to an active computer network.

Wake on LAN is also referred to as Remote Wake-up.įor Wake on LAN to work on a computer, it must have the following: The network adapter on the computer listens to network activity and will turn the computer ON once it receives a special data packet called a “Magic Packet” that triggers the boot up. My firmware: OpenWrt Barrier Breaker 14.07 / LuCI Trunk (0.Wake on LAN (WoL) is a technology that permits someone to turn ON a computer remotely.

When I use luci-app-wol I am able to wake up my NAS only with etherwake but not with WoL.ĭo I have to setup additional Traffic Rules or other General Settings? Internal IP address: "192.168.1.100 ()"īut I still can't wake up (from internet, not local LAN) my NAS which is directly connected to my router but it is possible to wake up my NAS from local LAN.

For that reason I've created the following port forwarding rule (Network->Firewall->Port Forwards):

I am trying to make all configuration using LuCi GUI.Īs far as I know I have first to setup port forwarding. Wake on Lan (from the internet) is an old topic and there are many thread about it but I still can't make it work on my OpenWrt router (Netgear N600 3700v2).